Netgear XCM8806 Chassis Hardware Installation Guide - Page 1274
con msdp peer ttl-threshold, con msdp sa-cache-server
View all Netgear XCM8806 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1274 highlights
NETGEAR 8800 Chassis Switch CLI Manual Usage Guidelines You can use this command only when either MSDP or the MSDP peer is disabled. The hold timer interval must be greater than the keep-alive timer interval. Example The following command configures the keep-alive and hold timer intervals for the MSDP peer 55.0.0.83: configure msdp peer 55.0.0.83 timer keep-alive 30 hold-time 60 configure msdp peer ttl-threshold configure msdp peer [ | all] ttl-threshold {vr } Description Configures the limit to which multicast data packets are sent in SA messages to an MSDP peer. If the time-to-live (TTL) in the IP header of an encapsulated data packet exceeds the TTL threshold configured, encapsulated data is not forwarded to MSDP peers. Syntax Description all remoteaddr ttl vrname Specifies all MSDP peers. Specifies the IP address of the MSDP peer on which to configure a TTL threshold. Specifies the TTL value. The range is 0 through 255. To restore the default value, enter a TTL value of 0 (zero). Specifies the name of the virtual router to which this command applies. If a name is not specified, it is extracted from the current CLI context. Default The default value is zero, meaning all multicast data packets are forwarded to the peer regardless of the TTL value in the IP header of the encapsulated data packet. Usage Guidelines This command allows you to configure a TTL value to limit multicast data traffic. Example The following command configures a TTL threshold of 5: configure msdp peer 192.168.45.43 ttl-threshold 5 configure msdp sa-cache-server configure msdp sa-cache-server {vr } 1274 | Chapter 28. MSDP Commands