Netgear XCM8806 Chassis Hardware Installation Guide - Page 1272
con msdp peer source-interface
View all Netgear XCM8806 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1272 highlights
NETGEAR 8800 Chassis Switch CLI Manual vrname Specifies the name of the virtual router to which this command applies. If a name is not specified, it is extracted from the current CLI context. Default By default, no SA entry limit is set. The router can receive an unlimited number of SA entries from an MSDP peer. Usage Guidelines You can use this command to prevent a distributed denial of service (DOS) attack. NETGEAR recommends that you configure an MSDP SA limit on all MSDP peer sessions. Note that a rejected SA cache entry is not included in the number of SA cache entries received from a peer. Example The following command configures the SA entry limit of 500 for the MSDP peer with the IP address 192.168.45.43: configure msdp peer 192.168.45.43 sa-limit 500 configure msdp peer source-interface configure msdp peer [ | all] source-interface [ | any] {vr } Description This command configures the source interface for the MSDP peer TCP connection. Syntax Description any ipaddress peer all remoteaddr vrname Specifies to use any interface as one end of the TCP connection. The source interface is selected based on the IP route entry used to reach the MSDP peer. The egress interface that reaches the MSDP peer is used as the source interface for the TCP connection. Basically, this command removes the previously configured source interface of the MSDP peer. Specifies the IP address of the MSDP router interface to use on one end of a TCP connection. The must be one of the MSDP router interface addresses; otherwise, the command fails and an error message displays. Specifies all MSDP peers. Specifies the IP address of the MSDP peer. Specifies the name of the virtual router to which this command applies. If a name is not specified, it is extracted from the current CLI context. 1272 | Chapter 28. MSDP Commands