Netgear XCM8806 Chassis Hardware Installation Guide - Page 1316
If you install the image at a later time, use the following command to install
View all Netgear XCM8806 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1316 highlights
NETGEAR 8800 Chassis Switch CLI Manual You can either continue the upgrade or cancel the action. If you continue the upgrade, the primary MSM downloads the new image to the I/O module and reboots. 5. Verify that the backup MSM comes up correctly and that the MSMs are synchronized using the following command: show switch The current state indicates which MSM is the primary (displayed as MASTER), which MSM is the backup (displayed as BACKUP), and if the backup MSM is synchronized with the primary MSM (displayed as In Sync). 6. Select the partition to download the image to and download and install the new NETGEAR 8800 software on the new backup MSM (this was the original primary MSM) using the following command: download image [ | ] {vr } msm Note: If the new backup MSM is installed in slot A, specify msm A. If the new backup MSM/MM is installed in slot B, specify msm B. Before the download begins, the switch asks if you want to install the image immediately after the download is finished. • When you download and install the software image on the alternate partition, you then need to reboot the switch. • If you install the image at a later time, use the following command to install the software: install image {} {msm } {reboot} 7. Verify that the new backup MSM comes up correctly and that the MSMs are synchronized using the following command: show switch The current state indicates which MSM is the primary (displayed as MASTER), which MSM is the backup (displayed as BACKUP), and if the backup MSM is synchronized with the primary MSM (displayed as In Sync). 8. Optionally, initiate failover from the new primary MSM to the new backup MSM using the following command: run msm-failover When you failover from the new primary MSM to the new backup MSM, this optional step restores the switch to the original primary and backup MSM. 9. Optionally, confirm that the failover is successful by checking the current state of the MSMs using the following command: show switch 1316 | Appendix A. Configuration and Image Commands