Netgear XCM8806 Chassis Hardware Installation Guide - Page 576

NETGEAR 8800 Chassis Switch CLI Manual The following command unlocks the FDB entries for the specified ports: configure ports 4,5 vlan accounting unlock-learning configure radius server client-ip configure radius {mgmt-access | netlogin} [primary | secondary] server [ | ] {} client-ip [] {vr } Description Configures the primary and secondary RADIUS authentication server. Syntax Description mgmt-access netlogin primary secondary ipaddress hostname udp_port ipaddress vr_name Specifies the RADIUS authentication server for switch management. Specifies the RADIUS authentication server for network login. Configures the primary RADIUS authentication server. Configures the secondary RADIUS authentication server. The IP address of the server being configured. The host name of the server being configured. The UDP port to use to contact the RADIUS authentication server. The IP address used by the switch to identify itself when communicating with the RADIUS authentication server. Specifies the virtual router on which the client IP is located. Note: User-created VRs are supported only on the platforms listed for this feature in Appendix A in the NETGEAR 8800 User Manual. Default The following lists the default behavior of this command: • The UDP port setting is 1812 • The virtual router used is VR-Mgmt, the management virtual router • Switch management and network login use the same primary and secondary RADIUS servers for authentication. Usage Guidelines Use this command to specify RADIUS server information. Use of the parameter requires that DNS be enabled. The RADIUS server defined by this command is used for user name authentication and CLI command authentication. 576 | Chapter 15. Security Commands