Netgear XCM8806 Chassis Hardware Installation Guide - Page 697

NETGEAR 8800 Chassis Switch CLI Manual Default N/A. Usage Guidelines Use this command to modify the attributes of an existing local network login account. You can update the following attributes associated with a local network login account: • Password of the local network login account • Destination VLAN attributes including: adding clients tagged or untagged, the name of the VLAN, and the VLAN ID Note: Passwords are case-sensitive and must have a minimum of 1 character and a maximum of 32 characters. You must create a local network login account before using this command. To create a local network login user name and password, use the following command: create netlogin local-user {encrypted} {} {vlan-vsa [[{tagged | untagged} [] | ]]} {security-profile } If the switch displays a message similar to the following: * XCM8810.14 # configure netlogin local-user purplenet ^ %% Invalid input detected at '^' marker. You might be attempting to modify a local network login account that is not present or the switch, or you might have incorrectly entered the account name. To confirm the names of the local network login accounts on your switch, use the following command: show netlogin local-users Additional Requirements This command applies only to the web-based and MAC-based modes of network login. 802.1x network login does not support local database authentication. You must have administrator privileges to use this command. If you do not have administrator privileges, the switch displays a message similar to the following: This user does not have permissions for this command. Passwords are case-sensitive. Passwords must have a minimum of 0 characters and a maximum of 32 characters. If you attempt to create a password with more than 32 characters, the switch displays the following message after you re-enter the password: Password cannot exceed 32 characters Chapter 16. Network Login Commands | 697