Netgear XCM8806 Chassis Hardware Installation Guide - Page 844

NETGEAR 8800 Chassis Switch CLI Manual A UDP forwarding policy must contain only the following attributes. Unrecognized attributes are ignored. • Match attributes • Destination UDP port number (destination-port) • Source IP address (source-ipaddress) • Action modified (set) attributes • Destination IP address (destination-ipaddress) • VLAN name (vlan) Policy files used for UDP forwarding are processed differently from standard policy files. Instead of terminating when an entry's match clause becomes true, each entry in the policy file is processed and the corresponding action is taken for each true match clause. For example, if the following policy file is used as a UDP forwarding profile, any packets destined for UDP port 67 are sent to IP address 20.0.0.5 AND flooded to VLAN to7: entry one { if match all { destination-port 67 ; } then { destination-ipaddress 20.0.0.5 ; } } entry two { if match all { destination-port 67 ; } then { vlan "to7" ; } } If you include more than one VLAN set attribute or more than one destination-ipaddress set attribute in one policy entry, the last one is accepted and the rest are ignored. Note: Although the XOS Policy manager allows you to set a range for the destination-port, you should not specify the range for the destination-port attribute in the match clause of the policy statement for the UDP profile. If a destination-port range is configured, the last port in the range is accepted and the rest are ignored. You can have two valid set statements in each entry of a UDP forwarding policy; one a destination-ipaddress and one a VLAN.The NETGEAR 8800 currently allows a maximum of 844 | Chapter 19. IP Unicast Commands