Netgear XCM8806 Chassis Hardware Installation Guide - Page 196
con mirror add ports anomaly, con mirroring add
View all Netgear XCM8806 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 196 highlights
NETGEAR 8800 Chassis Switch CLI Manual Example The following command sets the port priority for the LAG port 5:1 to be 55 (which will probably put that port in standby initially): configure lacp member-port 5:1 priority 55 configure mirror add ports anomaly configure mirror add ports anomaly Description Mirrors detected anomaly traffic to the mirror port. Syntax Description port list Specifies the list of ports. Default N/A. Usage Guidelines The command mirrors detected anomaly traffic to the mirror port. You must enable a mirror port and enable protocol anomaly protection on the slot that has the port to be monitored before using this command. After configuration, only detected anomaly traffic from these ports are dropped or mirrored to the mirror port, and legitimate traffic is not affected. This command takes effect after enabling anomaly-protection. configure mirroring add configure mirroring add [vlan {port }| port {vlan }] {ingress | egress | ingress-and-egress} Description Adds a particular mirroring filter definition on the switch. Syntax Description vlan name port port ingress Specifies a VLAN. Specifies a VLAN name. Specifies a port or slot and port. Specifies particular ports or slots and ports. Specifies packets be mirrored as they are received on a port. 196 | Chapter 5. Commands for Configuring Slots and Ports on a Switch