Netgear XCM8806 Chassis Hardware Installation Guide - Page 1143
enable bgp neighbor capability, all BGP neighbors.
View all Netgear XCM8806 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1143 highlights
NETGEAR 8800 Chassis Switch CLI Manual remoteaddr all Specifies an IP address of a BGP neighbor. Specifies all neighbors. Default Disabled. Usage Guidelines To create a new neighbor and add it to a BGP peer group, use the following command: create bgp neighbor peer-group {multi-hop} Example The following command enables the BGP neighbor session: enable bgp neighbor 192.168.1.17 enable bgp neighbor capability enable bgp neighbor [all | ] capability [ipv4-unicast | ipv4-multicast | route-refresh] Description This command enables multi protocol BGP (MBGP) and route-refresh capabilities for one or all BGP neighbors. Syntax Description all remoteaddr ipv4-unicast ipv4-multicast route-refresh Specifies all neighbors. Specifies an IP address of a BGP neighbor. Specifies BGP MP unicast capabilities. Specifies BGP MP multicast capabilities. Specifies ROUTE-REFRESH message capabilities. Default All capabilities are enabled by default. Chapter 25. BGP Commands | 1143