Netgear XCM8806 Chassis Hardware Installation Guide - Page 320

NETGEAR 8800 Chassis Switch CLI Manual • Operator limit violation • Disconnect • Discovery resistance, A2D failure • Classify, A2D failure • Sample, A2D failure • Device fault, A2D failure • Force on error The detail command lists all inline power information for the selected ports. Detail output displays the following information: • Configured Admin State-Displays the port's configured state; Enabled or Disabled. • Inline Power State-Displays the port power state. • MIB Detect Status-Displays the port state as reported by SNMP; valid values are as follows: • disabled • searching • delivering • fault • test • otherFault • denyLowPriority • Label-Displays the port's configured label. • Operator Limit-Displays the port's configured operator limit value. • PD Class-Displays the class type of connected PD: • Max Allowed Power-Displays the amount of maximum allowed power for a device of this class. • Measured Power-Displays the measured power, in watts, supplied to the PD. • Line Voltage-Displays the measured voltage. A value from 0 to 2 is valid for ports in a searching state. • Current-Displays the measured current, in milliamperes, drawn by the PD. • Fault Status-Displays the fault value. • Detailed Status The following information displays only with modular PoE devices: • Priority-Displays the port's configured PoE priority value, as follows: • Critical • High • Low 320 | Chapter 7. PoE Commands