Netgear XCM8806 Chassis Hardware Installation Guide - Page 1273
Defaults, Usage Guidelines, Example, Description, Syntax Description, con msdp peer timer
View all Netgear XCM8806 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1273 highlights
NETGEAR 8800 Chassis Switch CLI Manual Defaults By default, the source interface is selected based on the IP route entry used to reach the MSDP peer. The egress interface that reaches the MSDP peer is used as the source interface for the TCP connection. Usage Guidelines You must first disable MSDP or the MSDP peer before using this command. NETGEAR recommends that you configure a source interface for MSDP peers that are not directly connected. We also recommend using the loopback address as the MSDP peer connection endpoint. Example The following command configures a source interface for an MSDP peer with the IP address 192.168.45.43: configure msdp peer 192.168.45.43 source-interface 60.0.0.5 configure msdp peer timer configure msdp peer [ | all] timer keep-alive hold-time {vr } Description The command configures the keep-alive and hold timer intervals of the MSDP peers. Syntax Description hold-time-sec keep-alive-sec peer all remoteaddr vrname Specifies the hold timer interval in seconds, in the range of 3 through 75 seconds. Specifies the keep-alive timer interval in seconds, in the range of 1 through 60 seconds. Specifies all MSDP peers. Specifies the IP address of the MSDP peer. Specifies the name of the virtual router to which this command applies. If a name is not specified, it is extracted from the current CLI context. Default By default, the: • Keep-alive timer interval is 60 seconds. • Hold timer interval is 75 seconds. • SA timer interval is 60 seconds. Chapter 28. MSDP Commands | 1273