Netgear XCM8806 Chassis Hardware Installation Guide - Page 347
the order in which the items are assembled.
View all Netgear XCM8806 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 347 highlights
NETGEAR 8800 Chassis Switch CLI Manual process-slot source-line Specifies which slot number the message was generated. Specifies whether to include the source file name and line number. Default The following defaults apply to console display, memory buffer, NVRAM, and session targets: • timestamp-hundredths • date-mm-dd-yyyy • severity-on • event-name-condition • host-name-off • priority-off • process-name-off • process-slot-off • source-line-off The following defaults apply to syslog targets (per RFC 3164): • timestamp-seconds • date-mmm-dd • severity-on • event-name-none • host-name-off • priority-on • process-name-off • process-slot-off • source-line-off If a virtual router is not specified, VR-Mgmt is used. Usage Guidelines This command configures the format of the items that make up log messages. You can choose to include or exclude items and set the format for those items, but you cannot vary the order in which the items are assembled. When applied to the targets console or session, the format specified is used for the messages sent to the console display or telnet session. Configuration changes to the session target, be it either a telnet or console display target session, are in effect only for the duration of the session, and are not saved in FLASH. When this command is applied to the target memory-buffer, the format specified is used in subsequent show log and upload log commands. The format configured for the internal Chapter 8. Commands for Status Monitoring and Statistics | 347