Netgear XCM8806 Chassis Hardware Installation Guide - Page 208
con sharing delete ports, to determine
View all Netgear XCM8806 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 208 highlights
NETGEAR 8800 Chassis Switch CLI Manual • IPv6 packets-Uses the source and destination IPv6 addresses and Layer 4 port numbers. • MPLS packets-Uses the top, second, and reserved labels and the source and destination IP addresses. • Non-IP Layer 2-Uses the VLAN ID, the source and destination MAC addresses, and the ethertype. The xor hash algorithm guarantees that the same egress port is selected for traffic distribution based on a pair of IP addresses, Layer 4 ports, or both, regardless of which is the source and which is the destination. For IP-in-IP and GRE tunneled packets, the switch examines the inner header to determine the egress port. To verify your configuration, use the show ports sharing command. Example The following example configures the switch to examine the source IP address: configure sharing address-based custom ipv4 source-only configure sharing delete ports configure sharing delete ports Description Deletes ports from a link aggregation, or load-sharing, group. Syntax Description port port_list Specifies the logical port for a load-sharing group or a link aggregation group (LAG). This number also functions as the LAG Group ID. Specifies one or more ports or slots and ports to be grouped in the LAG. Default N/A. Usage Guidelines Use this command to dynamically delete ports from a load-sharing group, or link aggregation group (LAG). This command applies to static and dynamic link aggregation. Example The following example deletes port 3:12 from the LAG with the logical port, or LAG Group ID, 3:9: 208 | Chapter 5. Commands for Configuring Slots and Ports on a Switch