Netgear XCM8806 Chassis Hardware Installation Guide - Page 692
con netlogin dot1x timers
View all Netgear XCM8806 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 692 highlights
NETGEAR 8800 Chassis Switch CLI Manual configure netlogin dot1x timers configure netlogin dot1x timers [{server-timeout } {quiet-period } {reauth-period {reauth-max }} {supp-resp-timeout }] Description Configures the 802.1x timers for network login. Syntax Description server-timeout quiet-period reauth-period reauth-max supp-resp-timeout Specifies the timeout period for a response from the RADIUS server. The range is 1 to 120 seconds. Specifies the time for which the switch will not attempt to communicate with the supplicant after authentication has failed. The range is 0 to 65535 seconds. Specifies time after which the switch will attempt to re-authenticate an authenticated supplicant. The range is 0, 30 to 7200 seconds. Specifies the maximum reauthentication counter value. The range is 1 to 10. Specifies the time for which the switch will wait for a response from the supplicant. The range is 1 to 120 seconds. Default The defaults are as follows: • server-timeout-30 seconds • quiet-period-60 seconds • reauth-period-3600 seconds • reauth-max-3 • supp-resp-timeout-30 seconds Usage Guidelines To disable re-authentication, specify 0 for the reauth-period parameter. (If reauth-period is set to 0, reauth-max value doesn't apply.) If you attempt to configure a timer value that is out of range (not supported), the switch displays an error message. The following is a list of sample error messages: • server-timeout-ERROR: RADIUS server response timeout out of range (1..120 sec) • quiet-period-%% Invalid number detected at '^' marker. %% Input number must be in the range [0, 65535]. • reauth-period-ERROR: Re-authentication period out of range (0, 30..7200 sec) • reauth-counter-ERROR: Re-authentication counter value out of range (1..10) 692 | Chapter 16. Network Login Commands