Netgear XCM8806 Chassis Hardware Installation Guide - Page 835
con iproute priority
View all Netgear XCM8806 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 835 highlights
NETGEAR 8800 Chassis Switch CLI Manual Default If you do not specify a virtual router, the current virtual router context is used. Usage Guidelines Default routes are used when the router has no other dynamic or static route to the requested destination. A default gateway must be located on a configured IP interface. Example The following command deletes a default gateway: configure iproute delete default 123.45.67.1 configure iproute priority configure iproute {ipv4} priority [blackhole | bootp | ebgp | ibgp | icmp | ospf-as-external | ospf-extern1 | ospf-extern2 | ospf-inter | ospf-intra | rip | static] {vr } Description Changes the priority for all routes from a particular route origin. Syntax Description blackhole bootp ebgp ibgp icmp ospf-as-external ospf-extern1 ospf-extern2 ospf-inter ospf-intra rip static priority vrname Specifies the blackhole route. Specifies BOOTP. Specifies E-BGP routes Specifies I-BGP routes Specifies ICMP. Specifies OSPF as External routing. Specifies OSPF External 1 routing. Specifies OSPF External 2 routing. Specifies OSPFInter routing. Specifies OSPFIntra routing. Specifies RIP. Specifies static routes. Specifies a priority number in the range of 11 to 65534. Specifies a virtual router name. Chapter 19. IP Unicast Commands | 835