Netgear XCM8806 Chassis Hardware Installation Guide - Page 1268
con msdp peer mesh-group, con msdp peer no-default-peer
View all Netgear XCM8806 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1268 highlights
NETGEAR 8800 Chassis Switch CLI Manual configure msdp peer 192.168.45.43 description internal_peer The following command removes the description from an MSDP peer: configure msdp peer 192.168.45.43 description configure msdp peer mesh-group configure msdp peer [ | all] mesh-group [ | none] {vr } Description This command configures an MSDP peer to become a member of a mesh-group. To remove a peer from a mesh-group, enter the none CLI keyword for the mesh-group. Syntax Description mesh-group-name Specifies the name of the MSDP mesh-group. none Removes a peer from a mesh-group. peer all Specifies all MSDP peers. remoteaddr Specifies the IP address of the MSDP peer. vrname Specifies the name of the virtual router to which this command applies. If a name is not specified, it is extracted from the current CLI context. Default N/A. Usage Guidelines A mesh-group is a group of MSDP peers with fully meshed MSDP connectivity. Any SA messages received from a peer in a mesh-group are not forwarded to other peers in the same mesh-group. Mesh-groups achieve two goals: • Reduce SA message flooding • Simplify peer-RPF flooding Example The following command configures an MSDP peer with the IP address 192.168.45.43 to become a member of a mesh-group called "intra": configure msdp peer 192.168.45.43 mesh-group intra configure msdp peer no-default-peer configure msdp peer [ | all] no-default-peer {vr } 1268 | Chapter 28. MSDP Commands