Netgear XCM8806 Chassis Hardware Installation Guide - Page 47

NETGEAR 8800 Chassis Switch CLI Manual Example The following command enables continuous ICMP echo messages to be sent to a remote host: ping continuous 123.45.67.8 reboot reboot {time } {cancel} {msm } {slot | node-address | stack-topology {as-standby} } Description Reboots the switch or the module in the specified slot at a specified date and time. Syntax Description time cancel msm slot_id slot-number node-address stack-topology as-standby Specifies a reboot date in mm dd yyyy format and reboot time in hh mm ss format. Cancels a previously scheduled reboot. Specifies rebooting the MSM module. Specifies the slot--A or B--for an MSM module. Specifies the slot number currently being used by the active stack node that is to be rebooted Specifies the MAC address of the node to be rebooted Specifies that the entire NETGEAR 8800 is to be rebooted whether or not nodes are active Specifies that all stack nodes that are to be rebooted are to operate as if configured to not be master-capable Default N/A. Usage Guidelines If you do not specify a reboot time, the switch will reboot immediately following the command, and any previously scheduled reboots are cancelled. Prior to rebooting, the switch returns the following message: Do you want to save configuration changes to primary and reboot? (y - save and reboot, n - reboot without save, - cancel command) To cancel a previously scheduled reboot, use the cancel option. The modules that can be rebooted are management switch fabric modules (MSM)/management modules (MM). Chapter 2. Commands for Accessing the Switch | 47