Netgear XCM8806 Chassis Hardware Installation Guide - Page 480

NETGEAR 8800 Chassis Switch CLI Manual Table 14. Virtual Router Commands (Continued) [enable | disable] igmp snooping * [enable | disable] ipmcforwarding show igmp show igmp snooping show igmp group show igmp snooping cache * Indicates that other commands are available with these listed. The virtual router context simplifies configuration because you do not have to specify the virtual router for each individual protocol configuration command. The current VR context is indicated in the command line interface (CLI) prompt. For example, if you wish to configure OSPF for the user virtual router vr-manufacturing, you would change the virtual router context to that of vr-manufacturing. All the subsequent OSPF commands would apply to that virtual router, unless the context is changed again. A virtual router is identified by a name (up to 32 characters long). The name must be unique among the VLAN and virtual router names on the switch. For backward compatibility, you cannot name a virtual router VR-0, VR-1, or VR-2. Virtual router names are case insensitive. When a new virtual router is created, by default, no ports are assigned, no VLAN interface is created, and no support for any routing protocols is added. Example The following command changes the virtual router context to vr-acme: virtual-router vr-acme 480 | Chapter 11. Commands for Virtual Routers