Netgear XCM8806 Chassis Hardware Installation Guide - Page 222
disable smartredundancy, disable snmp traps port-up-down ports, Disables the Smart Redundancy feature.
View all Netgear XCM8806 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 222 highlights
NETGEAR 8800 Chassis Switch CLI Manual This command applies only to the data, or I/O ports on slots holding an MSM. The slots holding an MSM on the NETGEAR 8810 switch are 5 and possibly 6; the slots holding an MSM on the NETGEAR 8806 switch are 3 and possibly 4. Use the offline parameter to run the diagnostics offline. Example The following command disables slot 5 on the switch: disable slot 5 disable smartredundancy disable smartredundancy Description Disables the Smart Redundancy feature. Syntax Description port_list Specifies one or more ports or slots and ports. Default Enabled. Usage Guidelines The Smart Redundancy feature works in concert with the software-controlled redundant feature. When Smart Redundancy is disabled, the switch attempts only to reset the primary port to active if the redundant port fails. That is, if you disable Smart Redundancy, the traffic does not automatically return to the primary port once it becomes active again; the traffic continues to flow through the redundant port even after the primary port comes up again. Example The following command disables the Smart Redundancy feature on ports 1:1 to 1:4: disable smartredundancy 1:1-4 disable snmp traps port-up-down ports disable snmp traps port-up-down ports [ | all] Description Disables port up/down trap reception for specified ports. 222 | Chapter 5. Commands for Configuring Slots and Ports on a Switch