Netgear XCM8806 Chassis Hardware Installation Guide - Page 473

NETGEAR 8800 Chassis Switch CLI Manual If you plan to assign VR ports to a VLAN, be aware that the ports that you add to a VLAN and the VLAN itself cannot be explicitly assigned to different virtual routers. When multiple virtual routers are defined, consider the following guidelines while adding ports to a VR: • A VLAN can belong (either through explicit or implicit assignment) to only one VR. • If a VLAN is not explicitly assigned to a VR, then the ports added to the VLAN must be explicitly assigned to a single VR. • If a VLAN is explicitly assigned to a VR, then the ports added to the VLAN must be explicitly assigned to the same VR or to no VR. • If a port is added to VLANs that are explicitly assigned to different VRs, the port must be explicitly assigned to no VR. Example The following command adds all the ports on slot 2 to the virtual router vr-acme: configure vr vr-acme add ports 2:* configure vr add protocol configure vr add protocol Description Starts a Layer 3 protocol on a virtual router. Syntax Description vr-name protocol-name Specifies the name of the virtual router. Specifies the Layer 3 protocol. Default N/A. Usage Guidelines When a new virtual router is created, by default, no ports are assigned, no VLAN interface is created, and no support for any routing protocols is added. Use this command to start the Layer 3 protocol specified on the virtual router. The choices for protocol-name are: • RIP • OSPF • BGP • PIM Chapter 11. Commands for Virtual Routers | 473