Netgear XCM8806 Chassis Hardware Installation Guide - Page 1195
con pim ssm range, range with
View all Netgear XCM8806 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1195 highlights
NETGEAR 8800 Chassis Switch CLI Manual Default The default setting is 0 for both parameters. Usage Guidelines For the best performance, use default value of 0. Example The following command sets the threshold for switching to SPT: configure pim spt-threshold 4 16 configure pim ssm range configure pim ssm range [default | policy ] Description Configures the range of multicast addresses for PIM SSM. Syntax Description default policy-name Specifies the default address range, 232.0.0.0/8. Specifies a policy that defines the SSM address range. Default By default, no SSM range is configured. Using this command with the default keyword sets the range to 232.0.0.0/8. To reset the switch to the initial state, use the unconfigure pim ssm range command. Usage Guidelines You must disable PIM before configuring or unconfiguring a PIM-SSM range. Use the disable pim command. Initially, no range is configured for SSM. After a range is configured, you can remove the range with the unconfigure pim ssm range command. If you wish to change the PIM SSM range, you must first unconfigure the existing range, and then configure the new range. SSM requires that hosts use IGMPv3 messages to register to receive multicast group packets. When a range is configured for SSM, any IGMPv2 messages for an address in the range are ignored. Also, any IGMPv3 Exclude messages are ignored. Chapter 26. IP Multicast Commands | 1195