Netgear XCM8806 Chassis Hardware Installation Guide - Page 281

NETGEAR 8800 Chassis Switch CLI Manual Note: Network connectivity devices wait to detect LLDP MED TLVs from endpoints before they send out LLDP MED TLVs; so L2 network connectivity devices do not exchange LLDP MED messages. The following information is included in the LLDP MED capabilities TLV when it is transmitted: • The supported LLDP MED TLVs-For NETGEAR 8800 devices, these are capabilities, network policy, location, and extended power (extended power only advertised only on PoE-capable ports). • The MED device type-For NETGEAR 8800 devices, this is advertised as a network connectivity device (set to 4). Example The following command configures all ports to advertise MED capabilities to neighbors: configure lldp ports all advertise vendor-specific med capabilities configure lldp ports vendor-specific med location-identification configure lldp ports [all | ] [advertise | no-advertise] vendor-specific med location-identification [coordinate-based | civic-based | ecs-elin ] Description Configures the LLDP port to advertise or not advertise MED location information. You configure up to 3 different location identifiers. Syntax Description all port_list advertise advertise coordinate-based hex_value civic-based Specifies all ports on the switch. Specifies one or more ports or slots and ports. Specifies to send the information to neighbors. Specifies to send the information to neighbors. Specifies using the coordinate-based location identifier. This value is exactly 16 bytes long; see RFC 3825 for details. Enter a hexadecimal value with each byte separated by a colon. Or, you can obtain this value from a network management application. Note: This parameter is not used when the no-advertise parameter is configured. Specifies using the civic-based location identifier. This value must have a minimum length of 6 bytes; see RFC3825 for details. Chapter 6. Commands for Configuring LLDP | 281