Netgear XCM8806 Chassis Hardware Installation Guide - Page 1077

NETGEAR 8800 Chassis Switch CLI Manual • Out-updates • Last-error • FsmTransitions The command clear counters also resets all counter for all BGP neighbors. For BGP, the clear counters command is equivalent to the following BGP command: clear bgp neighbor all counters Example The following command resets the counters for the BGP neighbor at 10.20.30.55: clear bgp neighbor 10.20.30.55 counters configure bgp add aggregate-address configure bgp add aggregate-address {address-family [ipv4-unicast | ipv4-multicast]} {as-match | as-set} {summary-only} {advertise-policy } {attribute-policy } Description Configures a BGP aggregate route. Syntax Description address-family ipaddress as-match as-set summary-only advertise-policy attribute-policy The address family. BGP supports two address families: IPv4 unicast and IPv4 multicast. Specifies an IP network address and mask length. Generates autonomous system sequence path information (order of AS numbers in AS_PATH is preserved). Generates autonomous system set path information (order of AS numbers in AS_PATH is not preserved). Specifies to send only aggregated routes to the neighbors. Specifies the policy used to select routes for this aggregated route. Specifies the policy used to set the attributes of the aggregated route. Default If no address family is specified, IPv4 unicast is the default. Usage Guidelines Route aggregation is the process of combining the characteristics of several routes so that they are advertised as a single route. Aggregation reduces the amount of information that a BGP speaker must store and exchange with other BGP speakers. Reducing the information that is stored and exchanged also reduces the size of the routing table. Chapter 25. BGP Commands | 1077