Netgear XCM8806 Chassis Hardware Installation Guide - Page 761

NETGEAR 8800 Chassis Switch CLI Manual The following command enables edge safeguard on the RSTP edge port on slot 2, port 3 in STPD s1 on the switch: configure stpd s1 ports edge-safeguard enable 2:3 configure stpd ports link-type configure stpd ports link-type [[auto | broadcast | point-to-point] | edge {edge-safeguard [enable | disable] {bpdu-restrict} {recovery-timeout }}] Description Configures the ports in the specified STPD as auto, broadcast, edge, or point-to-point link types. Syntax Description stpd_name auto broadcast point-to-point port_list edge edge-safeguard enable disable bpdu-restrict recovery-timeout seconds Specifies an STPD name on the switch. Specifies the switch to automatically determine the port link type. An auto link behaves like a point-to-point link if the link is in full-duplex mode or if link aggregation is enabled on the port. Used for 802.1w configurations. Specifies a port attached to a LAN segment with more than two bridges. Used for 802.1D configurations. A port with broadcast link type cannot participate in rapid reconfiguration using RSTP or MSTP. By default, all STP.1D ports are broadcast links. Specifies a port attached to a LAN segment with only two bridges. A port with point-to-point link type can participate in rapid reconfiguration. Used for 802.1w and MSTP configurations. By default, all 802.1w and MSTP ports are point-to-point link types. Specifies one or more ports or slots and ports. Specifies a port that does not have a bridge attached. An edge port is placed and held in the STP forwarding state unless a BPDU is received by the port. Used for 802.1w and MSTP configurations. Specifies that the edge port be configured with edge safeguard, a loop prevention and detection mechanism. Used for 802.1w and MSTP configurations Specifies that edge safeguard be enabled on the edge port(s). Specifies that edge safeguard be disabled on the edge port(s). Disables port as soon as a BPDU is received. Time after which the port will be re-enabled. Specifies the time in seconds. The range is 60 to 600. The default is 300. Chapter 17. STP Commands | 761