Netgear XCM8806 Chassis Hardware Installation Guide - Page 931
enable iproute ipv6 sharing, enable neighbor-discovery refresh
View all Netgear XCM8806 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 931 highlights
NETGEAR 8800 Chassis Switch CLI Manual Usage Guidelines This command enables IP route compression for the IPv6 address family and VR. This command applies a compression algorithm to each IPv6 prefix in the IPv6 prefix database. Example The following example enables IP route compression for the IPv6 address family and the VR of the current CLI context. enable iproute ipv6 compression enable iproute ipv6 sharing enable iproute ipv6 sharing Description Enables load sharing if multiple routes to the same destination are available. When multiple routes to the same destination are available, load sharing can be enabled to distribute the traffic to multiple destination gateways. Only paths with the same lowest cost are shared. Syntax Description This command has no arguments or variables. Default Disabled. Usage Guidelines Configure static routes and OSPF as you would normally. NETGEAR 8800 supports route sharing across up to 8 static routes or ECMP routes for OSPF. However, on the NETGEAR 8800 family, by default up to 4 routes are supported. To support up to 8 routes on these switches, use the following command: configure iproute sharing max-gateways Example The following command enables load sharing for multiple routes: enable iproute ipv6 sharing enable neighbor-discovery refresh enable neighbor-discovery {vr } refresh Description Enables the IPv6 neighbor cache to refresh each entry before the timeout period expires. Chapter 20. IPv6 Unicast Commands | 931