Netgear XCM8806 Chassis Hardware Installation Guide - Page 1105

NETGEAR 8800 Chassis Switch CLI Manual none Removes any policy association. Default This feature is disabled by default. If no address family is specified, IPv4 unicast is the default. Usage Guidelines The half life is the period of time, in minutes, during which the accumulated penalty of a route is reduced by half. The range is 1 to 45 minutes, and the default is 15 minutes. The reuse limit is the penalty value below which a route is used again. The range is 1-20,000, and the default is 750. The suppress limit is the penalty value above which a route is suppressed. The range is 1-20,000, and the default is 2,000. The maximum hold down time is the maximum time a route can be suppressed, no matter how unstable it has been, as long as it no longer flaps. The range is 1-255 minutes, and the default is 4 * the half life. Instead of explicitly configuring the dampening parameters using the command line, you can associate a policy using the policy-filter option. Multiple sets of parameters can be supplied using a policy. Use the following command to disable route flap dampening for a BGP peer-group: configure bgp peer-group {address-family [ipv4-unicast | ipv4-multicast]} no-dampening Example The following command configures route flap dampening for the BGP peer group outer: configure bgp peer-group outer dampening configure bgp peer-group dont-allowin-as configure bgp peer-group {address-family [ipv4-unicast | ipv4-multicast]} dont-allowas-in Description Disables BGP from receiving and accepting a looped BGP route from the neighbors of the specified peer group, provided the number of occurrences of local AS number in AS-Path is less than or equal to that specified in as-count. Syntax Description peer-group-name Specifies a peer group Chapter 25. BGP Commands | 1105