Netgear XCM8806 Chassis Hardware Installation Guide - Page 925
create tunnel ipv6-in-ipv4
View all Netgear XCM8806 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 925 highlights
NETGEAR 8800 Chassis Switch CLI Manual Description Creates an IPv6-to-IPv4 (6to4) tunnel. Syntax Description tunnel_name source-address Specifies an IPv6 tunnel. Specifies an IPv4 address for the tunnel. Default N/A. Usage Guidelines This command will create a new IPv6-to-IPv4 (also known as a 6to4 tunnel), and add it to the system. A maximum of 1 6to4 tunnel can be configured on any particular virtual router. The tunnel name must be unique and cannot overlap the same name space as VLANs, other tunnels, or virtual routers. The name must begin with an alphabetical character and may contain alphanumeric characters and underscores (_), but it cannot contain spaces. The maximum allowed length for a name is 32 characters. For name creation guidelines and a list of reserved names, see the section "Object Names" in the NETGEAR 8800 User Manual. The source address of the tunnel must be one of the IPv4 addresses already configured on the switch. You cannot remove an IPv4 address from the switch if a tunnel that uses it still exists. Example The following command creates the 6to4 tunnel link35 with source address 192.168.10.1: create tunnel link35 6to4 source 192.168.10.1 create tunnel ipv6-in-ipv4 create tunnel ipv6-in-ipv4 destination source Description Creates an IPv6-in-IPv4 (6in4) tunnel. Syntax Description tunnel_name source-address Specifies an IPv6 tunnel. Specifies an IPv4 address for the tunnel. Chapter 20. IPv6 Unicast Commands | 925