Netgear XCM8806 Chassis Hardware Installation Guide - Page 985

NETGEAR 8800 Chassis Switch CLI Manual • A limit of 15 hops between the source and destination networks • A large amount of bandwidth taken up by periodic broadcasts of the entire routing table • Slow convergence • Routing decisions based on hop count; no concept of link costs or delay • Flat networks; no concept of areas or boundaries For larger networks, consider OSPFv3 as an alternative IGP. Example The following command enables RIPng for the whole router: enable ripng enable ripng export enable ripng export [direct | ospfv3 | ospfv3-extern1 | ospfv3-extern2 | ospfv3-inter | ospfv3-intra | static] [cost {tag } | policy ] Description Enables RIPng to redistribute routes from other routing functions. Syntax Description direct ospfv3 ospfv3-intra ospfv3-inter ospfv3-extern1 ospfv3-extern2 static cost tag Specifies interface routes (only interfaces that have IP forwarding enabled are exported). Specifies all OSPFv3 routes. Specifies OSPFv3-intra area routes. Specifies OSPFv3-inter area routes. Specifies OSPFv3 external route type 1. Specifies OSPFv3 external route type 2. Specifies static routes. Specifies the cost metric, from 0-15. If set to 0, RIPng uses the route metric obtained from the route origin. Specifies a tag number. Specifies a policy. Default Disabled. However, direct routes will always be advertised for all the interfaces where RIPng is enabled. For those interfaces where RIPng is not enabled, the corresponding direct route could be redistributed if direct route export is enabled through this command. Default tag is 0. Chapter 22. RIPng Commands | 985