Netgear XCM8806 Chassis Hardware Installation Guide - Page 1171
con igmp snooping leave-timeout
View all Netgear XCM8806 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1171 highlights
NETGEAR 8800 Chassis Switch CLI Manual Example The following command configures the group-vlan format: configure igmp snooping forwarding-mode group-vlan configure igmp snooping leave-timeout configure igmp snooping leave-timeout {vr } Description Configures the IGMP snooping leave timeout. Syntax Description leave_timeout_ms vrname Specifies an IGMP leave timeout value in milliseconds. Specifies a virtual router. Default 1000 ms. Usage Guidelines The leave-timeout is the IGMP leave override interval. If no other hosts override the IGMP leave by the end of this interval, the receiver port is removed. The range is 0 - 10000 ms (10 seconds). For timeout values of one second or less, you must set the leave-timeout to a multiple of 100 ms. For values of more than one second, you must set the leave-timeout to a multiple of 1000 ms (one second). Example The following command configures the IGMP snooping leave timeout: configure igmp snooping leave-timeout 10000 configure igmp snooping timer configure igmp snooping timer {vr } Description Configures the IGMP snooping timers. Syntax Description router_timeout host_timeout Specifies the time in seconds before removing a router snooping entry. Specifies the time in seconds before removing a host's group snooping entry. Chapter 26. IP Multicast Commands | 1171