Netgear XCM8806 Chassis Hardware Installation Guide - Page 1330

NETGEAR 8800 Chassis Switch CLI Manual Description Displays the current configuration for the system or the specified module. Syntax Description module-name detail Specifies the name of configuration module. The term configuration module refers to a feature in the firmware. By displaying a module, you can view the commands used to configure that feature. For example, to display all of the configurations that you made for only STP, specify the stp as the module-name. Displays configuration data including default. If the detail option is not specified, only the configuration changes you made to the factory defaults are shown. Default N/A. Usage Guidelines If the output scrolls off the top of the screen, you can use the enable clipaging command to pause the display when the output fills the screen. The default for clipaging is enabled. NETGEAR recommends using the show configuration command to view on the CLI your currently running switch configuration. These files have the .cfg file extension. Do not use a text editor to view or modify your XML-based switch configuration files. To save the configuration file as an ASCII-formatted file, and to view it with a text editor, see the upload configuration [ | ] {vr } and the load script {arg1} {arg2} ... {arg9} commands. When you specify show configuration only, the switch displays configuration information for each of the switch modules excluding the default data. You can display only the configuration of a module of interest by using the module-name keyword. For example, some of the modules are AAA, ACL, BGP, FDB, SNMP, and VLAN. Use TAB-completion to see a list. For example, to display the OSPF configuration of a user VR, the "module-name" is the name of the process, that is, show configuration ospf-3. You must have administrator access to view the output of the show configuration command. Depending on the software version running on your switch, the configurations on your switch, and the type of switch you have, additional or different configuration information may be displayed. Example This command shows the current configuration of the OSPF module in the switch: show configuration ospf 1330 | Appendix A. Configuration and Image Commands