Netgear XCM8806 Chassis Hardware Installation Guide - Page 187
terminate process, switch until you start the process again. A new process loads
View all Netgear XCM8806 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 187 highlights
NETGEAR 8800 Chassis Switch CLI Manual Depending on the software version running on your switch and the type of switch you have, you can restart different or additional processes. To see which processes you can restart, enter start process followed by TAB. The switch displays a list of available processes. To display the status of NETGEAR 8800 processes on the switch, including how many times a process has been restarted, use the show process {} {detail} {description} {slot } command. You can also use the start process command when upgrading a software modular package. For more information, see the section "Upgrading a Modular Software Package" in Appendix B of the NETGEAR 8800 User Manual. Note: After you stop a process, do not change the configuration on the switch until you start the process again. A new process loads the configuration that was saved prior to stopping the process. Changes made between a process termination and a process start are lost. Else, error messages can result when you start the new process. Example The following restarts the process tftpd: start process tftpd terminate process terminate process [forceful | graceful] {msm } Description Terminates the specified process on the switch. Chapter 4. Commands for Managing the NETGEAR 8800 Software | 187