Netgear XCM8806 Chassis Hardware Installation Guide - Page 1044
con ospfv3 area external-filter
View all Netgear XCM8806 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1044 highlights
NETGEAR 8800 Chassis Switch CLI Manual Usage Guidelines If you attempt to delete a range that was not configured, you will receive an error message. Example The following command is used to delete a summary network from area 0.0.0.1: configure ospfv3 area 0.0.0.1 delete range 2aaa:456:3ffe::/64 configure ospfv3 area external-filter configure ospfv3 {domain } area external-filter [ |none] Description Configures an external filter policy. Syntax Description domainName area-identifier policy-map none Specifies an OSPFv3 domain. OSPF-Default is the only one currently supported. Specifies the OSPFv3 target area. Specifies a policy. Specifies not to apply an external filter (removes the existing policy, if any). Default N/A. Usage Guidelines For switches configured to support multiple OSPFv3 areas (an ABR function), a policy can be applied to an OSPFv3 area that filters a set of OSPFv3 external routes from being advertised into that area, in other words, filtering some of the inbound AS-external-LSAs. OPSFv3 routers that do not have enough memory to hold the entire AS-external-LSAa should configure an external area filter to drop part of the external-LSAs. Configuring this policy will enable routers with limited resources to be put into an OSPFv3 network. Using the none mode specifies that no external filter is applied. Policy files for this command will only recognize the following policy attributes: • Match attributes • nlri / • Action (set) attributes • permit 1044 | Chapter 24. OSPFv3 Commands