Netgear XCM8806 Chassis Hardware Installation Guide - Page 1350
enable log debug-mode
View all Netgear XCM8806 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1350 highlights
NETGEAR 8800 Chassis Switch CLI Manual Default N/A. Usage Guidelines After the switch writes to the external memory card, and before you can view the contents on the card, you must ensure it is safe to remove the card from the external compact flash slot on the MSM/MM. Use the eject memorycard command to prepare the card for removal. After you issue the eject memorycard command, you can manually remove the card from the external compact flash slot on the MSM/MM and read the data on the card. If the configure debug coredumps memorycard command is in effect when you issue the eject memorycard command, the behavior is similar to issuing the configure debug coredumps off command. For more information about removing the external memory card, please refer to the hardware documentation. To access and read the data on the card, use a PC with appropriate hardware such as a compact flash reader/writer and follow the manufacturer's instructions to access the compact flash card and read the data. Example The following command prepares the external memory card to be removed from the external compact flash slot on the MSM/MM: eject memorycard enable log debug-mode enable log debug-mode Description Enables debug mode. The switch generates debug events. Syntax Description This command has no arguments or variables. Default Disabled. Usage Guidelines This command enables debug mode. Debug mode must be enabled prior to configuring advanced debugging capabilities. These include allowing debug messages, which can severely degrade performance. For typical network device monitoring, debug mode should remain disabled, the default setting. Debug mode should only be enabled when advised by 1350 | Appendix B. Troubleshooting Commands