Netgear XCM8806 Chassis Hardware Installation Guide - Page 1304
command, but displays information for all con d vMANs.
View all Netgear XCM8806 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1304 highlights
NETGEAR 8800 Chassis Switch CLI Manual * XCM8806.22 # show vman Name VID Protocol Addr Flags Proto Ports Virtual Active router /Total vman1 4089 ANY 0 /0 VR-Default Flags : (a) Learning Domain, (B) 802.1ah Backbone VMAN, (c) 802.1ad customer VLAN, (f) IP Forwarding Enabled, (F) Learning Disabled, (i) ISIS Enabled, (I) IP Forwarding lpm-routing Enabled, (L) Loopback Enabled, (m) IPmc Forwarding Enabled, (n) IP Multinetting Enabled, (N) Network LogIn vlan, (N) Network LogIn vlan, (o) OSPF Enabled, (O) Flooding Disabled, (p) PIM Enabled, (r) RIP Enabled, (S) 802.1ah Service VMAN, (T) Member of STP Domain, (v) VRRP Enabled The following example displays information on a single vMAN named vman1: XCM8806.23 # show vman vman1 VMAN Interface with name vman1 created by user Admin State: Enabled Tagging:Untagged (Internal tag 4089) Virtual router: VR-Default IPv6: None STPD: None Protocol: Match all unfiltered protocols Loopback: Disabled NetLogin: Disabled QosProfile: None configured Egress Rate Limit Designated Port: None configured Flood Rate Limit QosProfile: None configured Ports: 0. (Number of active ports=0) The show vman detail command shows all the information shown in the show vman command, but displays information for all configured vMANs. The following example shows the display from the show vman etherType command on switches that support only vMANs: vMan Ethertype: 0x88a8 The following example shows the display from the show vman etherType command: XCM8810.3 # show vman etherType Vman Primary EtherType : 0x88a8 The following example shows the display from the show vman etherType command when a secondary ethertype is configured: XCM8806.29 # show vman etherType Vman Primary EtherType : 0x9100 Vman Secondary EtherType : 0x8100 1304 | Chapter 29. vMAN (PBN) Commands