Netgear XCM8806 Chassis Hardware Installation Guide - Page 526
con ports qosprofile, con ports rate-limit egress, QoS Commands
View all Netgear XCM8806 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 526 highlights
NETGEAR 8800 Chassis Switch CLI Manual out-of-profile packet. Setting the DSCP value to none leaves the DSCP value in the packet unchanged. Example The following command configures the ACL meter maximum_bandwidth, assigns it a rate of 10 Mbps, and sets the out of profile action to drop: configure meter maximum_bandwidth committed-rate 10 Mbps out-action drop configure ports qosprofile configure ports {qosprofile} Description Creates a port-based traffic group, which configures one or more ingress ports to use a particular egress QoS profile. Syntax Description port_list qosprofile Specifies a list of ports or slots and ports. Specifies a QoS profile. Default All ingress ports have the default qosprofile of QP1. Usage Guidelines This command assigns traffic ingressing the specified port to a specified egress QoS profile. NETGEAR 8800 switches support eight egress QoS profiles (QP1 to QP8) for each port. Example The following command configures port 5 on slot 5 of the switch to use QoS profile QP3: configure ports 5:5 qosprofile QP3 configure ports rate-limit egress configure ports rate-limit egress [no-limit | [Kbps | Mbps | Gbps] {max-burst-size [Kb | Mb]}] Description Configures an egress traffic rate limit for a port or groups of ports. 526 | Chapter 14. QoS Commands