Netgear XCM8806 Chassis Hardware Installation Guide - Page 59

NETGEAR 8800 Chassis Switch CLI Manual • Monitors all installed PSUs, even installed PSUs that are disabled. • Enables and disables PSUs as required . • Powers up or down I/O modules based on available power and required power resources. • Logs power resource changes, including power budget, total available power, redundancy, and so on. • Detects and isolates faulty PSUs. Simple Network Time Protocol The NETGEAR 8800 supports the client portion of the Simple Network Time Protocol (SNTP) Version 3 based on RFC1769. SNTP can be used by the switch to update and synchronize its internal clock from a Network Time Protocol (NTP) server. When enabled, the switch sends out a periodic query to the indicated NTP server, or the switch listens to broadcast NTP updates. In addition, the switch supports the configured setting for Greenwich Mean time (GMT) offset and the use of Daylight Saving Time. configure node priority configure node slot priority Description Configures the priority of the node. Syntax Description slot_id node_pri Specifies the slot of the node. A is for the MSM/MM installed in slot A. B is for the MSM/MM installed in slot B. Specifies the priority of the node. The default 0 gives MSM-A a higher priority over MSM-B. The range is 1 to 100; 0 means you have not configured a node priority. Default Default node priority is 0. Usage Guidelines Use this command to configure the priority of the node. The lower the number, the higher the priority. The node priority is part of the selection criteria for the primary node. The following list describes the parameters used to determine the primary node: Chapter 3. Commands for Managing the Switch | 59