Netgear XCM8806 Chassis Hardware Installation Guide - Page 641

NETGEAR 8800 Chassis Switch CLI Manual remote_file local_file Specifies the name of the remote file (configuration file, policy file, image file, public key file) to be transferred. Specifies the name of the local file (configuration file, policy file, image file, public key file) to be transferred. Default The default settings for SSH2 parameters are as follows: • cipher-3des encryption • port-22 • compression-off • vr_name-VR-Mgmt Usage Guidelines You must be running the SSH2 module (ssh.xmod), which is under Export Control, in order to use the SCP2 command. SSH2 does not need to be enabled on the switch in order to use this command. This command logs into the remote host as and accesses the file . You will be prompted for a password from the remote host, if required. Host Name, User Name, and Remote IP Address Character Restrictions This section provides information about the characters supported by the switch for host names and remote IP addresses. When specifying a host name, user name, or remote IP address, the switch permits only the following characters: • Alphabetical letters, upper case and lower case (A-Z, a-z) • Numerals (0-9) • Period ( . ) • Dash ( - ) Permitted for host and user names • Underscore ( _ ) Permitted for host and user names • Colon ( : ) • At symbol ( @ ) Permitted only for user names • Slash ( / ) Permitted only for user names When naming the host, creating a user name, or configuring the IP address, remember the requirements listed above. Remote Filename Character Restrictions This section provides information about the characters supported by the switch for remote filenames. Chapter 15. Security Commands | 641