Netgear XCM8806 Chassis Hardware Installation Guide - Page 657

NETGEAR 8800 Chassis Switch CLI Manual Note: As part of the system health check, the system polls the Rate-limit Flood Counters every 5 minutes and looks for non-zero counters on a port. A HAL.RateLimit.Info log message is logged when this is first detected on a port to alert the user that something in the network has triggered the rate limiting to occur. The message is not be logged again unless the counters are cleared. Example The following command displays information for port 1:1 without a screen refresh on a NETGEAR 8800 switch. show port 1:1 rate-limit flood no-refresh Following is sample output from this command. BD-8810.1 # show port 1:1 rate-limit flood no-refresh Port Rate-Limit Discard Monitor Tue May 27 13:02:37 2008 Port Link Rx Pkt Rx Byte Rx Pkt Rx Pkt Flood Rate State Count Count Bcast Mcast Exceeded 1:1 R 5225 65230 2112 0 2112 > indicates Port Display Name truncated past 8 characters Link State: A-Active, R-Ready, NP-Port Not Present, L-Loopback show radius show radius {mgmt-access | netlogin} Description Displays the current RADIUS client configuration and statistics. Syntax Description mgmt-access netlogin Specifies configuration and statistics for the switch management RADIUS authentication server. Specifies configuration and statistics for the network login RADIUS authentication server. Default N/A. Chapter 15. Security Commands | 657