Netgear XCM8806 Chassis Hardware Installation Guide - Page 328

NETGEAR 8800 Chassis Switch CLI Manual Usage Guidelines This command unconfigures any previously configured operator limit for the specified ports. It resets the maximum power that any PD can draw to 15400 mW. Example The following command resets the limit on ports 3 to 6 of slot 5 on the switch to the default value of 15400 mW: unconfigure inline-power operator-limit ports 5:3-5:6 unconfigure inline-power priority ports unconfigure inline-power priority ports [all | ] Description On NETGEAR 8800 switches, unconfigures the PoE priority on the specified ports and returns the ports to the default PoE port priority value of low. Syntax Description all port_list Specifies all ports. Specifies one or more ports or slots and ports. Default Low. Usage Guidelines Use this to reset the PoE port priority on specified ports on the NETGEAR 8800 switch to the default value of low. If there are multiple ports on the NETGEAR 8800 switch at the same priority level (either configured or by default), and one of the ports must have power withdrawn because of excessive power demands, those ports with the lower port number are powered first. The higher port numbers have power withdrawn first in the case of equal PoE port priorities. Example The following command resets the PoE priority on ports 4 - 6 on slot 3 to low: unconfigure inline-power priority ports 3:4-3:6 unconfigure inline-power usage-threshold unconfigure inline-power usage-threshold 328 | Chapter 7. PoE Commands