Netgear XCM8806 Chassis Hardware Installation Guide - Page 402

NETGEAR 8800 Chassis Switch CLI Manual all event component severity only details Specifies that all events are to be displayed. Specifies that all the events associated with a particular component should be displayed. Specifies the minimum severity level of events to display (if the keyword only is omitted). Specifies that only events of the specified severity level are to be displayed. Specifies that detailed information, including the message format and parameter types, be displayed. Default If severity is not specified, then events of all severity are displayed. If detail is not specified, then summary only information is displayed. Usage Guidelines This command displays the mnemonic, message format, severity, and parameter types defined for each condition in the event set specified. See the command show log on page 387 for more information about severity levels. When the detail option is specified, the message format is displayed for the event conditions specified. The message format parameters are replaced by the value of the parameters when the message is generated. To get a listing of the components present in the system, use the following command: show log components Example The following command displays the event conditions of severity debug-summary or greater in the component STP.InBPDU: show log events stp.inbpdu severity debug-summary The following is sample output from this command: Comp SubComp Condition Severity Parameters STP InBPDU Drop Error 2 total STP InBPDU Ign Debug-Summary 2 total STP InBPDU Mismatch Warning 2 total The following command displays the details of the event condition PDUTrace in the component STP.InBPDU: show log events stp.inbpdu.pdutrace details The following is sample output from this command: Comp SubComp Condition Severity Parameters 402 | Chapter 8. Commands for Status Monitoring and Statistics