Netgear XCM8806 Chassis Hardware Installation Guide - Page 189
restarts, the configuration for that process is lost., configuration after terminating a process
View all Netgear XCM8806 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 189 highlights
NETGEAR 8800 Chassis Switch CLI Manual Note: Do not terminate a process that was installed since the last reboot unless you have saved your configuration. If you have installed a software module and you terminate the newly installed process without saving your configuration, your module may not be loaded when you attempt to restart the process with the start process command. To preserve a process's configuration during a terminate and (re)start cycle, save your switch configuration before terminating the process. Do not save the configuration or change the configuration during the process terminate and re(start) cycle. If you save the configuration after terminating a process, and before the process (re)starts, the configuration for that process is lost. You can also use the terminate process command when upgrading a software modular package. For more information, see the section "Upgrading a Modular Software Package" in Appendix B of the NETGEAR 8800 User Manual. Example The following initiates a graceful termination of the process tftpd: terminate process tftpd graceful Chapter 4. Commands for Managing the NETGEAR 8800 Software | 189