Netgear XCM8806 Chassis Hardware Installation Guide - Page 56
Syntax Description, Default, Usage Guidelines, Example, Each router along the path is displayed.
View all Netgear XCM8806 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
NETGEAR 8800 Chassis Switch CLI Manual Syntax Description vr vrid ipv4 ipv6 host ttl from port icmp Specifies a virtual router. Note: User-created VRs are supported only on the platforms listed for this feature in Appendix A of the NETGEAR 8800 User Manual. Specifies which virtual router. Note: User-created VRs are supported only on the platforms listed for this feature in Appendix A of the NETGEAR 8800 User Manual. Specifies IPv4 transport. Specifies IPv6 transport. Specifies the host of the destination endstation. Configures the switch to trace up to the time-to-live number of the switch. Uses the specified source address in the ICMP packet. If not specified, the address of the transmitting interface is used. Specifies the UDP port number. Configures the switch to send ICMP echo messages to trace the routed path between the switch and a destination endstation. Default N/A. Usage Guidelines Use this command to trace the routed path between the switch and a destination endstation. Each router along the path is displayed. Example The following command enables the traceroute function to a destination of 123.45.67.8: traceroute 123.45.67.8 The following is sample output that displays when the traceroute fails: traceroute to 10.209.10.37, 30 hops max 1 0.0.0.0 * !u * !u * !u --- Packet Response/Error Flags --(*) No response, (!N) ICMP network unreachable, (!H) ICMP host unreachable, (!P) ICMP protocol unreachable, (!F) ICMP fragmentation needed, (!S) ICMP source route failed, (!u) Transmit error, network unreachable, (!f) Transmit error, fragmentation needed, (!t) General transmit error 56 | Chapter 2. Commands for Accessing the Switch