Netgear XCM8806 Chassis Hardware Installation Guide - Page 450

NETGEAR 8800 Chassis Switch CLI Manual Flags : (c) 802.1ad customer VLAN (d) NetLogin Dynamically created VLAN, (D) VLAN Admin Disabled, (f) IP Forwarding Enabled, (F) Learning Disabled, (L) Loopback Enabled, (m) IPmc Forwarding Enabled, (M) Subscriber VLAN, (n) IP Multinetting Enabled, (N) Network Login VLAN, (o) OSPF Enabled, (O) Flooding Disabled, (p) PIM Enabled, (r) RIP Enabled, (R) Sub-VLAN IP Range Configured, (s) Sub-VLAN, (S) Super-VLAN, (t) Network VLAN, (T) Member of STP Domain, (v) VRRP Enabled, Total number of VLAN(s) : 9 The following is an example of the show vlan Default command: * XCM8806.5 # show vlan "Default" VLAN Interface with name Default created by user Admin State: Enabled Tagging: 802.1Q Tag 1 Virtual router: VR-Default IPv6: None STPD: s0(Disabled,Auto-bind) Protocol: Match all unfiltered protocols Loopback: Disabled NetLogin: Disabled QosProfile: None configured Egress Rate Limit Designated Port: None configured Flood Rate Limit QosProfile: None configured Ports: 90. (Number of active ports=3) Untag: 1:1, 1:2, 1:7, 1:8, 1:9, 1:12, 1:13, 1:14, 1:15, 1:16, 1:19, 1:20, 1:21, 1:22, 1:23, 3:2, 3:3, 3:4, 3:5, 3:6, 4:1, 4:2, 4:3, 4:4, 4:5, 4:8, 5:1, 5:2, 5:3, *5:4, 5:7, 5:8, 6:1, 6:2, 6:3, 6:7, 6:8, 6:9, 6:10, 6:12, 6:15, 6:16, 6:17, 6:18, 6:19, 6:22, 6:23, *6:24, 6:25, 6:26, 6:29, 6:30, 6:31, 6:32, 6:33, 6:36, 6:37, 6:38, 6:39, 6:40, 6:43, 6:44, 6:45, 6:46, 6:47, Flags: (*) Active, (!) Disabled, (g) Load Sharing port (b) Port blocked on the vlan, (m) Mac-Based port (a) Egress traffic allowed for NetLogin (u) Egress traffic unallowed for NetLogin (t) Translate VLAN tag for Private-VLAN (s) Private-VLAN System Port, (L) Loopback port (e) Private-VLAN End Point Port 1:10, 1:17, 1:24, 3:7, 4:6, 5:5, 6:5, 6:13, 6:20, 6:27, 6:34, 6:41, *6:48 1:11, 1:18, 3:1, 3:8, 4:7, 5:6, 6:6, 6:14, 6:21, 6:28, 6:35, 6:42, 450 | Chapter 9. VLAN Commands