Netgear XCM8806 Chassis Hardware Installation Guide - Page 1353
Default, Usage Guidelines, Viewing Diagnostics
View all Netgear XCM8806 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1353 highlights
NETGEAR 8800 Chassis Switch CLI Manual A | B Specifies which MSM/MM to run diagnostics on. • A specifies the MSM installed in slot A. • B specifies the MSM installed in slot B. Default N/A. Usage Guidelines Depending on your platform, use this command to run diagnostics on the switch, slot, management module, or stack port. On an I/O module, the extended diagnostic routine can require significantly more time to complete, depending on the number of ports on the module. On a management module, the module is taken offline while the diagnostics test is performed. Once the diagnostic test is completed, the MSM reboots, and becomes operational again. Note: NETGEAR 8810 switch-If you run diagnostics on slots 5 and 6 with an MSM installed in those slots, the diagnostic routine tests the I/O subsystem of the MSM. NETGEAR 8806 switch-if you run diagnostics on slots 3 and 4 with an MSM installed in those slots, the diagnostic routine tests the I/O subsystem of the MSM. NETGEAR 8800 series switches-To run diagnostics on the management portion of the master MSM, specify slot A or B. Viewing Diagnostics To view results of the last diagnostics test run, use the following command: show diagnostics {slot [ | A | B]} If the results indicate that the diagnostic failed on a module, replace the module with another module of the same type. If the results indicate that the diagnostic failed on the switch, contact NETGEAR Technical Support. Appendix B. Troubleshooting Commands | 1353