Netgear XCM8806 Chassis Hardware Installation Guide - Page 474
con vr delete ports, VR-Default, VR-Mgmt and VR-Control, vr-acme
View all Netgear XCM8806 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 474 highlights
NETGEAR 8800 Chassis Switch CLI Manual MPLS is the only protocol that you can add to or delete from the VR-Default virtual router. You cannot add or delete any other protocols from VR-Default, and you cannot add or delete any protocols from the other system virtual routers, VR-Mgmt and VR-Control. Example The following command starts RIP on the virtual router vr-acme: configure vr vr-acme add protocol rip configure vr delete ports configure vr delete ports Description Removes a list of ports from the virtual router specified. Syntax Description vr-name portlist Specifies the name of the virtual router. Specifies the ports to remove from the virtual router. Default By default, all ports are assigned to the virtual router, VR-Default. Usage Guidelines When a new virtual router is created, by default, no ports are assigned, no VLAN interface is created, and no support for any routing protocols is added. Use this command to remove ports from a virtual router. Since all ports are initially assigned to VR-Default, you might need to delete the desired ports first from the virtual router where they reside, before you add them to the desired virtual router. Example The following command removes all the ports on slot 2 from the virtual router vr-acme: configure vr vr-acme delete ports 2:* configure vr delete protocol configure vr delete protocol Description Stops and removes a Layer 3 protocol on a virtual router. 474 | Chapter 11. Commands for Virtual Routers