Netgear XCM8806 Chassis Hardware Installation Guide - Page 430

NETGEAR 8800 Chassis Switch CLI Manual Error: Protocol conflict when adding untagged port 1:2. Either add this port as tagged or assign another protocol to this VLAN. The ports that you add to a VLAN and the VLAN itself cannot be explicitly assigned to different virtual routers. When multiple virtual routers are defined, consider the following guidelines while adding ports to a VLAN: • A VLAN can belong (either through explicit or implicit assignment) to only one VR. • If a VLAN is not explicitly assigned to a VR, then the ports added to the VLAN must be explicitly assigned to a single VR. • If a VLAN is explicitly assigned to a VR, then the ports added to the VLAN must be explicitly assigned to the same VR or to no VR. • If a port is added to VLANs that are explicitly assigned to different VRs, the port must be explicitly assigned to no VR. Note: User-created VRs are supported only on the platforms listed for this feature in Appendix A in the NETGEAR 8800 User Manual. On switches that do not support user-created VRs, all VLANs are created in VR-Default and cannot be moved. For more information on configuring Spanning Tree Domains, see Chapter 17, STP Commands. Note: If you use the same name across categories (for example, STPD names), NETGEAR recommends that you specify the identifying keyword as well as the actual name. If you do not use the keyword, the system may return an error message. Example The following command assigns tagged ports 1:1, 1:2, 1:3, and 1:6 to a VLAN named accounting: configure vlan accounting add ports 1:1, 1:2, 1:3, 1:6 tagged configure vlan add ports private-vlan translated configure {vlan} add ports private-vlan translated Description Adds the specified ports to the specified network VLAN and enables tag translation for all subscriber VLAN tags to the network VLAN tag. Translation from network VLAN tag to each subscriber VLAN tag is done by default in a private VLAN. 430 | Chapter 9. VLAN Commands