Netgear XCM8806 Chassis Hardware Installation Guide - Page 1131
disable bgp neighbor originate-default, disable bgp neighbor remove-private-AS-numbers
View all Netgear XCM8806 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1131 highlights
NETGEAR 8800 Chassis Switch CLI Manual This command disables BGP Multiprotocol and route-refresh capabilities for one or all neighbors. After the capabilities have been enabled, the BGP neighbor announces its capabilities to neighbors in an OPEN message. Example The following command disables the route-refresh feature for all neighbors: disable bgp neighbor all capability route-refresh disable bgp neighbor originate-default disable bgp [{neighbor} | neighbor all] {address-family [ipv4-unicast | ipv4-multicast]} originate-default Description Removes a default route to a single BGP neighbor or to all BGP neighbors. Syntax Description neighbor remoteaddr neighbor all ipv4-unicast ipv4-multicast Specifies the IP address of a BGP neighbor for which the default route is removed. Specifies that default routes are to be removed for all BGP neighbors. Specifies that the removed default routes apply to IPv4 unicast routes. If you do not specify an address family, the command applies to IPv4 unicast routes. Specifies that the removed default routes apply to IPv4 multicast routes. Default Disabled. BGP does not automatically originate and advertise default routes to BGP neighbors. Usage Guidelines This command can be successfully executed at any time, irrespective of whether local BGP or the remote BGP peer is enabled or disabled. Example The following command removes default routes for IPv4 unicast traffic for all BGP peer nodes: disable bgp neighbor all originate-default disable bgp neighbor remove-private-AS-numbers disable bgp neighbor [ | all] remove-private-AS-numbers Chapter 25. BGP Commands | 1131