Netgear XCM8806 Chassis Hardware Installation Guide - Page 950

21. RIP Commands 21 This chapter describes commands used for the interior gateway protocol RIP. Routing Information Protocol (RIP) is an Interior Gateway Protocol (IGP) first used in computer routing in the Advanced Research Projects Agency Network (ARPAnet) as early as 1969. It is primarily intended for use in homogeneous networks of moderate size. To determine the best path to a distant network, a router using RIP always selects the path that has the least number of hops. Each router that data must traverse is considered to be one hop. The routing table in a router using RIP contains an entry for every known destination network. Each routing table entry contains the following information: • IP address of the destination network • Metric (hop count) to the destination network • IP address of the next router • Timer that tracks the amount of time since the entry was last updated The router exchanges an update message with each neighbor every 30 seconds (default value), or if there is a change to the overall routed topology (also called triggered updates). If a router does not receive an update message from its neighbor within the route timeout period (180 seconds by default), the router assumes the connection between it and its neighbor is no longer available. A new version of RIP, called RIP version 2 (RIPv2), expands the functionality of RIP version 1 to include: • Variable-Length Subnet Masks (VLSMs) • Next-hop addresses • Support for next-hop addresses allows for optimization of routes in certain environments • Multicasting If you are using RIP with supernetting/Classless Inter-Domain Routing (CIDR), you must use RIPv2 only, and RIP route aggregation must be turned off. Chapter 21. RIP Commands | 950