Netgear XCM8806 Chassis Hardware Installation Guide - Page 317
show inline-power configuration ports
View all Netgear XCM8806 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 317 highlights
NETGEAR 8800 Chassis Switch CLI Manual • Legacy-The status of the legacy mode, which allows detection of many non-standard PDs. Note: For additional information on inline power parameters, refer to the show power budget command. Example The following command displays inline power status for the switch: show inline-power (Demo) XCM8806.2 # show inline-power Inline Power System Information Configured : Enabled System Power Surplus : 2473 Watts available for budgeting Redundant Power Surplus : 1438 Watts available for budgeting to maintain N+1 Power Usage Threshold : 70 percent (per slot) Disconnect Precedence : deny-port Budgeted Measured Slot Inline-Power Firmware Status Power (Watts) Power (Watts) Legacy 6 Enabled Operational 50 W 0 W Disabled show inline-power configuration ports show inline-power configuration ports Description Displays inline power configuration information for the specified ports. Syntax Description port_list Specifies one or more ports. Default N/A. Usage Guidelines The output displays the following inline power configuration information for the specified ports: • Config-Indicates whether the port is enabled to provide inline power: • Enabled: The port can provide inline power. Chapter 7. PoE Commands | 317