Netgear XCM8806 Chassis Hardware Installation Guide - Page 815

NETGEAR 8800 Chassis Switch CLI Manual Usage Guidelines Permanent IP ARP entries are not affected. This command is specific to a single virtual router, and it applies to the current virtual router if you do not specify a virtual router. Example The following command removes a dynamically created entry from the IPARP table: clear iparp 10.1.1.5 configure bootprelay add configure bootprelay add {vr } Description Configures the addresses to which BOOTP requests should be directed. Syntax Description ip_address vrid Specifies an IP address. Specifies a VR name. Default If you do not specify a virtual router, the current virtual router context is used. Usage Guidelines After IP unicast routing has been configured, you can configure the switch to forward Dynamic Host Configuration Protocol (DHCP) or BOOTP requests coming from clients on subnets being serviced by the switch and going to hosts on different subnets. To configure the relay function, follow these steps: 1. Configure VLANs and IP unicast routing. 2. Configure the addresses to which DHCP or BOOTP requests should be directed, using the following command: configure bootprelay add 3. Enable the DHCP or BOOTP relay function, using the following command: enable bootprelay Example The following command configures BOOTP requests to be directed to 123.45.67.8: configure bootprelay add 123.45.67.8 Chapter 19. IP Unicast Commands | 815