Netgear XCM8806 Chassis Hardware Installation Guide - Page 530
QP3 - 3, Normal
View all Netgear XCM8806 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 530 highlights
NETGEAR 8800 Chassis Switch CLI Manual maxbw committed_rate peak_rate priority_number port_list all The maximum bandwidth (maxbw) option specifies the peak rate as a percentage of the maximum port speed. The range is 0 to 100%, and the default value is 100. When autonegotiation is off, the peak rate is the specified percentage of the configured port speed. When autonegotiation is on, the peak rate is the specified percentage of the maximum port speed (the switch does not detect the negotiated port speed). Specifies a committed information rate in Kbps (k) bits or Mbps (m). Specifies a peak rate in Kbps (k) bits or Mbps (m). Specifies a number that selects the service priority setting for the QoS profile. The accepted values are: • 1 (priority Low) • 2 (priority LowHi) • 3 (priority Normal) • 4 (priority NormalHi) • 5 (priority Medium) • 6 (priority MediumHi) • 7 (priority High) • 8 (priority HighHi) Specifies a list of slots and ports to which the parameters apply. Specify ports in the following formats: 3-5, 2:5, 2:6-2:8. Specifies this applies to all ports on the device. Default • Minimum bandwidth-0% • Maximum bandwidth-100% • Priority-By default, each qosprofile is assigned a different priority level: • QP1 - 1, Low (the lowest priority) • QP2 - 2, LowHi • QP3 - 3, Normal • QP4 - 4, NormalHi • QP5 - 5, Medium • QP6 - 6, MediumHi • QP7 - 7, High • QP8 - 8, HighHi (highest priority) Usage Guidelines The maximum bandwidth value can be configured as either: • an absolute percentage of the total maximum link speed, regardless of the currently configured or negotiated speed OR 530 | Chapter 14. QoS Commands